Sump Pumps/Sewage Ejectors In Whitby, Ajax, Pickering, Ontario, And Surrounding Areas
Your home’s defense against flooding is its sump pump. In contrast, when it begins to fail, it can worsen the existing problem or even cause your basement or crawlspace to flood. If your sump pump constantly runs or stops working, look for a professional for plumbing service in Whitby, ON, to get help.
Troubleshooting Methods for Sump Pump Problems
Clogged Switches & Sump Pumps
Sump pumps with switches can fail for a variety of reasons. Dirt or debris in the sump pit may cause the switch to fail. In addition, the sump pump’s float switch may be stuck. We can check to see if you need some basic maintenance, a repair, or a new airtight lid and pedestal.
Loss of Power
When a storm knocks out your power, your circuit breaker trips or the pump gets unplugged. Your sump pump won’t work. We can help you install a high-performance, battery-powered pump and verify that it has a battery backup and alarm system, so you know if your home is vulnerable.
Ice in Discharge Lines
Water is discharged from a sump pump through discharge lines. However, it is not uncommon for drainage pipes to freeze during the winter. Licensed technicians can install line attachments that prevent water from flowing into the icy lines. Also, experts can reroute your lines to remain clear, covered, and far from your foundation when performing sump pump repair in Whitby, ON.
The Sump Pump is an Incorrect Size
There is a right-sized sump pump for every home, but your sump pump may be too big or too small if it keeps running constantly. An undersized sump pump will struggle to remove water from your basement, resulting in a shorter life cycle. Most of the time, replacing an old sump pump with another of the same size is safe. If your home sits in a swampy/marshy area or contains a high vertical lift or long-running pipes, a licensed plumber can recommend a larger-sized pump if necessary.
Incorrect Installation
We discussed how an improperly-installed sump pump could prevent water from draining from your home. With a poorly installed pump, you may find that it wasn’t stabilized, set onto a clean surface, or given a check valve to prevent backflow and a relief hole from releasing air pressure from the discharge line.
Hire the Best Plumbers
If you’re seeking for a plumber near me, look no further than Plumbing & Heating Heros. Whenever you have a problem with your sump pump, you can trust our team to solve it. Homeowners can rely on us for reliable sump pump repair and installation.
If you are looking for water heater repair in Whitby, ON, then you can contact Plumbing & Heating Heroes. We offer our services by keeping in mind our customer’s requirements.
Frequently Asked Questions
plumbingcontactform
A sump pump is a submersible unit installed in a drainage pit below a house in a basement or crawl space. It is significant for your home since it will help protect your basement from flooding.
Drainage tanks are typically 4.5 feet wide, 8 feet long, and 6 feet high. Drainage tanks can be of different sizes. A 1000-gallon tank is the smallest.
To determine if you need a sump pump, you need to find out if your home tends to collect water.
- If flooding is a problem in your area, you'll need it, but even if you're in an area that doesn't have that danger, you may still be storing excess water.
- If it's completely dry, it's probably safe. However, if it's damp, run a dehumidifier in your basement and check the humidity again in a few weeks.
Sump pumps fall into two categories: pedestal and submersible.
- The pedestal sump pump is installed above ground. It is easier to install and maintain than underwater units, and more affordable.
- The submersible pump can be covered with a lid and is virtually impenetrable.
On average, a sump pump may last approximately ten years. Even if your device is relatively new, you should always consider its performance. Replace floor pumps after about 30 years and submersible pumps after ten years. Contact plumbing and drainage service providers that provide sump pump repair in Whitby.
A sump pump is a mechanism that senses rising water levels and pressure and prevents these water levels from getting too high. These pumps use a switch to detect the water level of the pool.
When the water level rises and the switch trips, the pump turns on, and water flows down the drain away from the house's foundation. Pumps can be electric, battery, or water. For any sewage backup in Whitby, you can contact a professional.
Primary drainage pumps are the most common type found in homes. You can pump thousands of gallons an hour out of your basement/house:
- Battery Backup Sump Pumps
A battery backup pump provides added security during a power outage during flooding.
- Water-Powered Sump Pumps
A water sump pump is an emergency backup pump that helps keep your house dry when the primary sump pump is not working.
- Combination Sump Pumps
As you can imagine, the combined units are merely a primary pump and a backup pump.
- Sewage Ejector Pump
Sewage ejector pumps are most often installed in houses with bathrooms, laundry facilities, or other plumbing appliances in the basement.
The most energy-effective sump pumps utilize less than 0.5 horsepower. A 1/3 HP sump pump uses about 800-1050 W when running and 13,000-4,100 W at start-up, while a 0.5 HP sump pump uses more than 1.5 times that at start-up alone.
A 0.5 horsepower sewage pump costs about $30 a month during the wet season but becomes less efficient and more expensive as it ages.
